无定形Fe (OH)3 和Fe3 O4 共沉淀态As的化学提取 |
摘要点击 3430 全文点击 1563 投稿时间:2012-03-02 修订日期:2012-05-08 |
查看HTML全文
查看全文 查看/发表评论 下载PDF阅读器 |
中文关键词 铁氧化物 As形态 老化 提取时间 液固比 Fe/As摩尔比 |
英文关键词 iron oxides arsenic species ageing extraction time extractant-to-solid ratio Fe/As molar ratio |
|
中文摘要 |
无定形铁氧化物结合态砷的迁移性和生物可利用性易受环境变化影响. 分别以1 mol·L-1盐酸和0.2 mol·L-1草酸铵缓冲溶液为提取剂,以新制备和室温老化(3个月、6个月)的共沉淀态Fe(OH)3-As和Fe3O4-As为提取对象,研究提取时间、液固比、Fe/As摩尔比和室温老化对As提取效率的影响. 结果表明, 1 mol·L-1盐酸提取Fe(OH)3-As、Fe3O4-As共沉淀时液固比应分别为50、200左右,0.2 mol·L-1草酸铵缓冲溶液提取Fe(OH)3-As、Fe3O4-As共沉淀时需保证加入的草酸根与固相中Fe的摩尔比分别为4、2.5; 盐酸和草酸铵缓冲溶液提取时间2 h即可. 样品Fe/As摩尔比和室温老化对Fe(OH)3-As共沉淀的溶解提取影响不大,但对Fe3O4-As共沉淀的提取影响比较大,Fe/As摩尔比越大,Fe3O4-As共沉淀越不易被提取; 老化时间越长,其中共沉淀的As越不易被溶解提取. 值得注意的是:盐酸和草酸铵缓冲溶液提取过程中如果有不溶固相存在,会发生As的再吸附,使无定形铁氧化物共沉淀态砷的测定不准确. |
英文摘要 |
The mobility and bioavailability of As combining with amorphous Fe oxides is vulnerable to the environment. In order to figure out the specific effects of ageing time, Fe/As molar ratio and extractant-to-solid ratio on As extraction procedure, we chose 1 mol·L-1 hydrochloride acid and 0.2 mol·L-1 ammonium oxalate/oxalic acid as extractants to extract synthetic Fe(OH)3-As and Fe3O4-As co-precipitates. The results showed that: 1 During the extraction of Fe(OH)3-As and Fe3O4-As co-precipitates by 1 mol·L-1 hydrochloride acid, extractant-to-solid ratio should be 50 and 200, respectively; while extracted by 0.2 mol·L-1 ammonium oxalate/oxalic acid, the molar ratio of C2O42- to Fe in Fe(OH)3 and Fe3O4 solid phases should be 4 and 2.5, 2 The extraction time conducted by hydrochloride acid and ammonium oxalate/oxalic acid should be within 2 hours. 3 The Fe-to-As molar ratio and ageing at room temperature had a little influence on the extraction of Fe(OH)3-As co-precipitation, but significantly influenced on Fe3O4-As co-precipitation. With increase of the Fe/As molar ratio and extension of the ageing time, the Fe3O4-As co-precipitate became more difficult to be dissolved. 4 It was worth noting that, As would be re-adsorpted by the insoluble solid phase during the extraction by hydrochloride acid and ammonium oxalate/oxalic acid. So the inaccurate measurement would emerge during the extraction of As combining with amorphous Fe oxides. |
|
|
|