首页  |  本刊简介  |  编委会  |  投稿须知  |  订阅与联系  |  微信  |  出版道德声明  |  Ei收录本刊数据  |  封面
酸性体系中Pd/PPy/foam-Ni电极电化学还原三氯甲烷
摘要点击 1661  全文点击 1185  投稿时间:2008-03-06  修订日期:2008-05-07
查看HTML全文 查看全文  查看/发表评论  下载PDF阅读器
中文关键词  聚吡咯  Pd/PPy/foam-Ni电极  三氯甲烷  电催化加氢脱氯
英文关键词  polymeric pyrrole  Pd/PPy/foam-Ni electrode  chloroform  electrocatalytic hydrodechlorination
作者单位
孙治荣 北京工业大学北京市水质科学与水环境恢复工程重点实验室, 北京100124 
葛慧 北京工业大学北京市水质科学与水环境恢复工程重点实验室, 北京100124 
胡翔 北京化工大学化学工程学院北京100029 
彭永臻 北京工业大学北京市水质科学与水环境恢复工程重点实验室, 北京100124 
中文摘要
      在沉积电流密度5 mA·cm-2,沉积时间40 min条件下,通过电沉积方法制备Pd/PPy/泡沫镍(foam-Ni)电极,以Pd/PPy/foam-Ni电极为阴极研究酸性体系中三氯甲烷的电化学还原脱氯,实验在室温条件下进行.采用循环伏安法对电极进行测试,Pd/PPy/foam-Ni电极在-500 mV (vs Hg/Hg2SO4)左右获得很大的氢吸附峰电流值,峰电流值为-100 mA.扫描电镜(SEM)分析表明,聚吡咯的引入改变了Pd在电极表面的沉积形态,使电极表面具有很好的空间延伸性.在酸性体系中进行Pd/PPy/foam-Ni电极对三氯甲烷的电化学还原脱氯实验,结果表明,综合考虑三氯甲烷去除率及脱氯过程电流效率,在保证脱氯过程电流效率为44.17%的条件下,三氯甲烷的去除率为49.23%,此时最佳脱氯电流密度为0.05 mA·cm-2,最佳脱氯时间为180 min,实现了在酸性水溶液体系中,低初始浓度三氯甲烷较好的脱氯效果.
英文摘要
      Palladium/polymeric pyrrole film/foam-nickel (Pd/PPy/foam-Ni) composite electrode were prepared by the electrodeposition method with the electrodepositing current density of 5 mA·cm-2 and the electrodepositing time of 40 min. Electrochemical reductive dechlorination of chloroform in acidic system was investigated using the Pd/PPy/foam-Ni electrode at ambient temperature. The electrochemical deposition behaviors of Pd/PPy/foam-Ni electrode were studied by means of cyclic voltammetry (CV). Cyclic voltammetry results reveal that the large hydrogen adsorption peak current of -100 mA on Pd/PPy/foam-Ni electrode was obtained at about -500 mV (vs Hg/Hg2SO4). SEM micrographs show that the addition of polymeric pyrrole changed the distributing configuration of Pd microparticles on the electrode and Pd/PPy/foam-Ni electrode possessed a good spatial extension. Chloroform dechlorination experimentes were conducted in acid system. Dechlorination experimental results indicate that, with the integrated analysis of removal efficiency and current efficiency, with the high current efficiency of 44.17%, the removal efficiency of chloroform on Pd/PPy/foam-Ni electrode was 49.23%,under the optimum conditions of the dechlorination current density of 0.05 mA·cm-2 and the dechlorination time of 180 min. In acid aqueous solution, with low initial concentration of chloroform, the results of dechlorination experiment were preferable.

您是第52956701位访客
主办单位:中国科学院生态环境研究中心 单位地址:北京市海淀区双清路18号
电话:010-62941102 邮编:100085 E-mail: hjkx@rcees.ac.cn
本系统由北京勤云科技发展有限公司设计  京ICP备05002858号-2