| 亚硝化-厌氧氨氧化联合工艺处理高含氮废水的研究 |
| 摘要点击 2235 全文点击 1215 投稿时间：2005-07-15 修订日期：2005-10-24 |
| 查看HTML全文
查看全文 查看/发表评论 下载PDF阅读器 |
| 中文关键词 亚硝化 厌氧氨氧化 联合工艺 氮 废水 |
| 英文关键词 nitritation ANAMMOX combined process nitrogen wastewater |
|
| 中文摘要 |
| 采用实验室规模的亚硝化-厌氧氨氧化联合工艺,研究其对高含氮、低C/N废水的处理能力.结果表明,亚硝化反应器的水力停留时间控制在1.0d时,亚硝化活性比较稳定,进水氨氮浓度对其影响不大.进水氨氮浓度在400～600 mg/L时,出水亚硝酸氮浓度都在260～280 mg/L,可以通过控制进水氨氮浓度调节出水亚硝酸氮/氨氮的比率.亚硝化反应器出水的亚硝酸氮/氨氮的比率对厌氧氨氧化脱氮率有重要的作用.当进水氨氮浓度为480 mg/L时,出水中亚硝酸氮/氨氮的比率为1.2左右,进入厌氧氨氧化反应器的氮物质去除率达到 |
| 英文摘要 |
| Combination of a nitritation process and anoxic ammonium oxidation(ANAMMOX) process for the treatment of ammonia rich influents is evaluated.Herein the combined process was studied with manmade synthetic wastewater.Research results show that when the hydraulic retention time(HRT) was 1 day,the nitritation activity was stable and the influent ammonium concentration has little effect on it.When the influent ammonium concentration is 400～600 mg/L, the effluent nitrite concentration is always between 260 mg/L and 280 mg/L,so the effluent nitrite/ammonium ratio can be adjust by control the influent ammonium concentration.The total nitrogen elimination was depended strongly on the nitrite/ammonium ratio in the inlet of the ANAMMOX reactor.When the inlet ammonium was 480 mg/L of the combined process,the nitrite/ammonium ratio of the nitritation process was about 1.2,the total nitrogen elimination was 84%. |
|
|
|
